![]() ![]() Destination address (IP address or network) = Set to the address of the target computer/server.Note, that the system must be part of a local network that is reachable from the firewall. You can either select it from the dropdown boxes or enter the IP address directly. Now, you will need to pick the server to which you are going to forward packets to. ![]() If you have public IP address space in the destination zone, you don't need to check the NAT checkbox, but make sure to select ACCEPT as rule action further down below. Where practical, limit the possible source(s) by selecting a host, group of hosts or specific network.Ĭhoose the following to forward a WAN / RED port to a single internal server.Īs this is a NAT rule, check " Use Network Address Translation (NAT)" and select " Destination NAT (Port forwarding)". Usually, you do not need to specify anything other than the defaults. Step 1: Sourceĭefine the source from which the service you are forwarding to is accessible. Source and destination ports can only be defined for protocols that uses ports, i.e. To create a new port-forwarding rule, select > Firewall > Firewall Rules and press the " New rule" button. Setting up a port-forwarding rule requires an originating source and new destination to be specified, with optional protocol constraints to further refine the rule. Packets that are received by the firewall can be transparently forwarded to a new destination. Technical BackgroundĪ port-forward is another term for a Destination NAT. Please checkout out the firewall rules reference for further description. This guide explains how to set up a port-forwarding rule really quickly. Setting up port-forwarding is a very common task. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |